best lawn mower engine oil image
bkcrum
Is it possible to flush out diesel fuel in a gasoline lawn mower engine without buying a new lawn mower?
Any recommendation would be appreciated.
Answer
Yes you can do it! You didn't say if it's a push or a rider, either way it's simple! If you have a push mower first remove the air filter, tip the mower over (with a bucket under to catch the diesel) getting as much out as possable. Some engine oil will run out that's why you removed the air filter to keep oil out of the element. Refill the tank with fresh gasoline. You may have to use a starting fluid (sparingly) to counteract the diesel in the carb, but it will start. run the tank dry and you should be over the crisis of diesel fuel. Oh don't forget to replace the clean air filter!
Yes you can do it! You didn't say if it's a push or a rider, either way it's simple! If you have a push mower first remove the air filter, tip the mower over (with a bucket under to catch the diesel) getting as much out as possable. Some engine oil will run out that's why you removed the air filter to keep oil out of the element. Refill the tank with fresh gasoline. You may have to use a starting fluid (sparingly) to counteract the diesel in the carb, but it will start. run the tank dry and you should be over the crisis of diesel fuel. Oh don't forget to replace the clean air filter!
How could i put a lawn mower engine on a dirt bike?
Justice S
I was wanting to know how to put a lawn mower engine on a dirt bike. and how i could make sure the oil gets to it if i do put it on. And would it even work?
Answer
Kids have been powering mini-bikes with lawn mower engines for as long as I can remember. You need an engine with a horizontal crankshaft. A vertical crank would require too much ridiculous engineering to transmit the power to the rear wheel.
Use a proprietary variable-speed belt to drive a jack-shaft which in turn drives the chain to the rear wheel. I have seen mini-bikes built this way which work much better than the old method of a single-speed chain drive direct from a centrifugal clutch on the end of the crank.
Kids have been powering mini-bikes with lawn mower engines for as long as I can remember. You need an engine with a horizontal crankshaft. A vertical crank would require too much ridiculous engineering to transmit the power to the rear wheel.
Use a proprietary variable-speed belt to drive a jack-shaft which in turn drives the chain to the rear wheel. I have seen mini-bikes built this way which work much better than the old method of a single-speed chain drive direct from a centrifugal clutch on the end of the crank.
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar