best 10 lawn mowers image
Bob
I have about a 10 year old cub cadet lawn mower and need to get the engine pulley off but can't. I already have the bolt and the clutch off, but I can't get the pulley to break free. What should I do?
Answer
This is always a difficult problem for the beginner, especially when the engine is old and the pulley has been attached for so long. The pulley has rust welded to the shaft. There is but one cure. I have had to remove hundreds over the years that are rust welded on. You need heat and lots of it. If you can get the engine to someone with oxy-acetylene, then great. You need to gently heat the pulley all over, just enough to get the pulley to expand. If you have a wheel bearing puller, then that helps too.
Okay, so you have heated the pulley and fitted the bearing puller.... Tighten the puller as tight as it will go, the lay the engine on its side and sharply hit the nut-end of the puller, real hard. You might have to do this a couple of times, keeping the heat on the pulley. Re-tighten the puller and hit the puller again and again.
This is the only way you will remove the pulley. Best of luck..
mmalky: 50 years fixing large and small lawnmower and automotive engines.
This is always a difficult problem for the beginner, especially when the engine is old and the pulley has been attached for so long. The pulley has rust welded to the shaft. There is but one cure. I have had to remove hundreds over the years that are rust welded on. You need heat and lots of it. If you can get the engine to someone with oxy-acetylene, then great. You need to gently heat the pulley all over, just enough to get the pulley to expand. If you have a wheel bearing puller, then that helps too.
Okay, so you have heated the pulley and fitted the bearing puller.... Tighten the puller as tight as it will go, the lay the engine on its side and sharply hit the nut-end of the puller, real hard. You might have to do this a couple of times, keeping the heat on the pulley. Re-tighten the puller and hit the puller again and again.
This is the only way you will remove the pulley. Best of luck..
mmalky: 50 years fixing large and small lawnmower and automotive engines.
where can i get 2 stroke lawn mower?
SparkyG
I am looking for either two stroke lawn mowers or a 4 stroke but with oil pump. Or is there a company that builds mowers that can built about 10 units for me. Reasong being most of my work is done on a 30 - 45 degrees slope. If you know of a place please let me know.
Answer
Lawn boy carries a two-stroke.
Lawn boy carries a two-stroke.
Powered by Yahoo! Answers
Tidak ada komentar:
Posting Komentar